L-3 Communications CEU, Руководство пользователя

Страница: 218 / 312

Remote Control Operations STE User’s Manual
8-8 Rel. 2.6
8-5.2.1 Command and Response Summary
Refer to Table 8-4 for a listing of the commands, their descriptions, and the success or failure responses
for each. Each is amplified in paragraphs following the table. Parameters within brackets are optional
(e.g., ATH[0]).
Table 8-4. Command and Response Summary
Response
CMD Description
Success Failure
+++
Escape to Command State 0/OK None – stays in On-line
state
A
Go off-hook in Answer mode [optional call set up
commands and
responses]
3/NO CARRIER (at end
of call) 4/ERROR
A/
Repeat last command Responses appropriate
for repeated command. Responses appropriate
for repeated command.
Go off-hook and dial “n” that can
include any of the 16 dial characters
(0-9, #, *, and AUTOVON call
precedence levels A, B, C, and D)
and the following dialing modifiers: P,
T, W, comma, period and semi-colon. [optional call set up
commands and
responses]
3/NO CARRIER (at end
of call) 4/ERROR or
45/BLACKLISTED;
UNABLE TO PLACE
CALL; TRY LATER
Dn
If in the command state with an active
call, dial “n” which can include any of
the 16 dial characters (0-9, #, *, and
AUTOVON call precedence levels A,
B, C, and D). 0/OK
4/ERROR
E0 Inhibit echo command 0/OK 4/ERROR
E1 Enable echo command 0/OK 4/ERROR
G[0]
Provision for or go secure (Only valid
in the Command State while in a
nonsecure voice call) xx/CONNECT
<rate or vocoder> 4/ERROR
G1
Go nonsecure (Only valid for an
outgoing call if enabled by Remote
Nonsecure voice strap). 41/CONNECT PCM 4/ERROR
H0
Go on-hook 3/NO CARRIER or
0/OK 4/ERROR
H1 Go off-hook 0/OK 4/ERROR
M[0] Mute 0/OK 4/ERROR
M1 Un-mute 4/ERROR 4/ERROR
O[0]
Return to On-line State CONNECT or
CONNECT <rate> or
CONNECT <vocoder> 3/NO CARRIER
Q[0] Enable result codes 0/OK 4/ERROR
Q1 Disable result codes None 4/ERROR
Sn=x Set the value of S-Register n to x 0/OK 4/ERROR
Sn?
Show the value of S-Register n <value>
0/OK 4/ERROR
V[0] Send short form result codes 0 4/ERROR
V1 Send long form result codes OK 4/ERROR
X[0] Extended result code control 0 0/OK 4/ERROR
X1 Extended result code control 1 0/OK 4/ERROR
X2 Extended result code control 2 0/OK 4/ERROR
X3 Extended result code control 3 0/OK 4/ERROR