KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 52 / 66

52
The greasing points are identified by a label featuring a white grease pump on a blue background.
Some grease nipples are located under guards or protective caps.
We strongly recommend that you take the time when your machine is delivered to open all of the
guards to identify the various greasing points. Remember that regular greasing will increase the life of
rotating parts considerably.
For cleanliness, the conveyor is housed in a case. In order to eliminate the build-up of product from
the bottom of the case, it is preferable to open the shutter once a week.
The following procedure should be applied:
-
Shift the original tractor distributor lever to the continuous pumping position.
- Switch on the tractor PTO and engage the feed rotor.
-
Start the conveyor in forward motion for a few seconds to bring the built-up product to the back of the
conveyor case.
-
Stop the conveyor and disengage the feed rotor followed by the tractor PTO.
-
Switch off the tractor engine and remove the key from the ignition.
- Pull the locking handles (A) located on either side.
- Release the hooks holding the ring (B).
- Fully open the shutter (C).
- Using a brush or similar tool, remove any product
that may be left behind.
- Lift the shutter and insert the two hooks into the
ring. It is important to hook the rings before lifting
the handles.
- Lift the handles to lock the shutter.
WAIT FOR A FEW MOMENTS UNTIL THE MACHINE IS AT A COMPLETE
STANDSTILL.
A
B
C
5.1 GREASING
5.2 CLEANING THE CONVEYOR