KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 8 / 66

8
5. Before hitching the machine, make sure that there is sufficient ballast on the front axle of the
tractor. Ballast should be added to the special supports according to the tractor manufacturer’s
instructions. The front axle load must be not be less than 20% of the unladen tractor weight.
6. Couple the hitch safety cable to a fixed point on the tractor with the snap link.
Special Precautions for Transport
1. Steering accuracy, tractor adhesion, roadholding and effective braking are affected by factors
such as the weight of the towed machine, ballasting of the front axle and state of the land or road.
It is therefore essential to observe the rules of care applicable to every use.
2. When driving on public roads, follow the Highway Code. Before entering public roads, make sure
that all guards and signalling devices (lights, reflectors, etc.) required by law are fitted and working
properly.
3. It is strictly prohibited to use the machine to carry persons or animals whilst in operation or transit.
4. Do not exceed the maximum axle weight and the gross vehicle weight rating.
5. Observe the maximum vehicle width for transport on public roads.
Using the Machine
1. Beware! Never stand in the working area of the machine.
2. Never stand between the tractor and the machine unless the parking brake has been applied and/
or chocks placed under the wheels.
3. Before starting operations using the loading equipment (arm and grab) or raising the machine
body, make sure that there can be no accidental contact with a power line.
4. Never stand by the delivery chute while the machine is in operation.
5. Before using the machine, make sure that the guards are fitted and in good condition. Damaged
guards must be replaced immediately by KUHN recommended parts.
6. All remote controls must be positioned such that they cannot accidentally set off an operation
which may lead to a risk of accident or damage.
7. Do not use the loading components (arm or grab) as lifting gear.
8. Before engaging the PTO, make sure that the speed setting and direction of rotation comply with
the manufacturer’s instructions. Never engage the PTO with the tractor engine switched off.
Driving Components
1. Before every use, make sure that PTO and universal drive shaft guards are fitted and in good
condition. Any damaged guards must be replaced immediately by KUHN recommended parts.