KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 35 / 66

35
Before using the machine for the first time under a load, it must be
tested to make sure that the tractor-machine combination is in working
order. MAKE SURE THAT THERE ARE NO FOREIGN BODIES OR
ACCESSORIES INSIDE THE MACHINE.
Procedure
- Make sure that you can change PTO speed. If the machine is equipped with a hydraulic unit, check
that the unit can be set to neutral.
As gear shifting is not synchronised, it may be necessary to engage the
tractor PTO quickly and operate the gear control lever at the same time.
- Select a PTO speed (270 or 540 min
-1
).
- Align the tractor and the machine, then engage the PTO drive and leave the tractor idling.
- Gradually increase the engine speed until the PTO speed reaches 540 min
-1
.
- Start the feed rotor (check that the LED lights up on the control) then the conveyor (test in both
directions). Now check that the machine is running smoothly and free from vibration. Reduce the
engine speed once again until it is idling.
If the machine is noisy or vibrating abnormally, stop the PTO immediately and refer to the troubleshooting
section or contact your dealer. When the problem has been solved, start the test procedure again
from the beginning.
- Operate the hydraulically-controlled components and check the operation of the machine.
- Stop the PTO, switch off the control unit and switch off the tractor engine.
Should one of the hydraulic functions fail to work or should it run in the wrong direction, check the hose
connections and start the test procedure again from the beginning.
- Finally check that the lighting and singalling equipment (side lights, brake lights and turn-signal
indicators) are in good working order.
2.6 NO-LOAD TESTS
2.7 UNHITCHING
- Before unhitching the machine, bring the grab inside the body and lower the arm completely (ram
rods fully retracted).
- Lay the machine on the ground so that it is stable (adjust the parking stand if necessary).
- Before unhitching the machine, switch off the tractor engine and take the key out of the ignition.
- Uncouple the hydraulic pressure and return hoses and the electrical connections.
- Apply the machine’s parking brake.
- Remove the hitch safety cable.
- Unhitch.