KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 36 / 66

36
3. MACHINE OPERATION
RECOMMENDATIONS FOR USE
Before carrying out any maintenance on the machine, switch off the
tractor engine, take the key out of the ignition, wait until all moving
parts are at a standstill and uncouple the universal drive shaft.
3.1 LOADING SILAGE
If the machine is equipped with a hydraulic unit, the speed control unit
must be set to neutral.
3.1.1 Approaching the Silage
- Set the hydraulic distributor control lever to the continuous
pumping position.
- Raise the arm and grab as far as possible to ensure good
visibility and prevent the silage from collapsing as a result
of a collision.
- Lower the machine as far as possible without the heel plate
scraping the ground then back up to the face of the silage.
- Put the heel plate of the machine on the ground just before
coming into contact with the silage.
Note: In the case of a silage clamp, position the machine slightly aslant in order to load as close as
possible to the wall.
Never attempt to back your way into the silage by force.
3.1.2 Loading the Machine
Always start by cutting the silage
from the top.
- From the tractor cab or the platform, position the grab so
as to cut away a chunk of silage about 40 cm thick.
- Move the grab back and forth while slowly lowering the
arm.
- When the claw is down, bring it back inside the body while
raising the arm for optimum loading.