KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 42 / 66

42
Operating tips: To stop feedingmomentarily (posts, obstacles, etc.), simply disengage
the feed rotor (the conveyor stops at the same time).
To avoid the risks of jamming in difficult conditions, watch the engine speed.
Slow down the conveyor, or even reverse the direction of rotation, as soon as
the engine speed drops or the belt begins to slip. In all cases where overloading
occurs, it is important to let the feed rotor empty itself before putting the
conveyor back into forward motion.
NEVER ATTEMPT TO CLEAR PRODUCT AWAY BY HAND OR USING A
TOOL WHEN THE MACHINE IS RUNNING.
When the machine is loaded, we strongly recommend against leaving the
conveyor running in reverse longer than is necessary.
Before starting the feed rotor, make sure that the conveyor speed is set to
position 0 to prevent a load being fed into the turbine.
3.5.1 Feeding
The rate of product output is adjusted by:
- the variation in tractor engine speed: control of the hydraulic oil flow and PTO speed.
- the conveyor speed.
3.5.2 Feeding Silage
- Start up the tractor PTO and bring the engine up to its nominal speed.
- Switch the tractor’s hydraulic distributor to continuous pumping.
- Set the regulating system to the “up” position.
- Point the delivery chute downwards such that the machine wheel does not run over the distributed
forage which should be properly channelled towards the ground or into the trough.
- Start up the feed rotor with the clutch (until the indicator lights up).
- To deliver the product, start the conveyor running forwards and adjust
the speed.
- Feed the forage regularly onto the conveyor using the grab.
- When feeding is over, bring the arm and grab right in.
Stop the conveyor and disengage the feed rotor. Close the delivery
chute then disengage the tractor PTO.
Operating tips: The conveyor speed is adjusted by the control unit according to feed speed
and product distribution factors, as well as the type of silage.