KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 37 / 66

37
Never overpack the silage
against the feed rotor
- Raise the arm with the grab inside the body and
repeat the loading operation until the machine is
completely full.
-
When the machine is loaded, bring the grab into the
tailgate position without overpacking the silage
against the feed rotor.
3.2 LOADING BALES
If the machine is equipped with a hydraulic unit, the speed control unit
must be set to neutral.
3.2.1 Round Bales (1.35 x ø 1.80)
- Raise the arm and the grab for good visibility.
- Back the machine up to the bale and position
the heel plate as close as possible to the
ground.
- Envelop the bale by fully extending the grab
and bringing down the arm until it comes into
contact with the bale.
-
Keeping the arm in contact with the bale,
back up slowly. When the bale starts to enter
the machine body, finish off by combining
grab and arm movements.
-
Raise the rear end of the machine to keep the
bale inside.
- Raise the arm slightly to decompress the bale.
- Remove the twine then lower the arm again.