KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 62 / 66

62
A
l Belt driving the beater bar slipping
for no apparent reason.
- Check the belt tension (see section 5 “Maintenance”).
l Turbine rotating, feed rotor engaged - Check the conveyor speed setting. Position the
but no product appears. setting knob at the required graduation mark.
- Make sure that the product to be distributed is not
packed against the feed rotor. Release the pressure
on the product inside the machine body by opening
the grab slightly. It is also possible to switch the
conveyor briefly to reverse and then back to forward
motion.
l Turbine rattling when PTO engaged - Engage the PTO gradually at the recommended
speed. If the tractor is equipped with a hydraulic PTO
clutch, contact the dealer to solve the problem with
the progressive clutch rate irrespective of tractor
engine speed.
l Arm lowered too slowly or too - The arm lowering speed can be adjusted by the flow
quickly or grab fails to move when rate limiter (A) under the left-hand hood of the
arm is lowered. machine.
Note: The arm raising/lowering speed is adjusted at
the factory to achieve two identical speeds.
- Unscrew the check screw.
- Turn the wheel to the right to reduce the flow and, in
turn, the lowering speed.
- Turn the wheel to the left to increase the flow and, in
turn, the lowering speed.
- Tighten the check screw.
An excessive arm lowering speed
can damage the arm and the rubber
stops on the machine body, or even
the body itself.