KUHN ALTOR 6070, Инструкция по эксплуатации

Страница: 38 / 66

38
Note: For easier feeding of hay or haylage or straw blowing with a round bale, we advise you to
make sure that the bale is loaded so that it will unroll naturally. This ensures a better feed
through to the turbine - feed rotor assembly and therefore improves the quality of distribution
or straw blowing.
3.2.2 Cubic Bales (3 x 1.45 x 1.45)
- Raise the arm and the grab for good visibility.
- Back the machine up to the bale and position the heel plate as close as possible to the ground.
- Fully extend the grab and lower the arm until it
comes into contact with the middle of the bale.
- Keeping the arm in contact with the bale, back up
slowly. When the bale starts to enter the machine
body, finish off by combining grab and arm
movements.
- When the bale is loaded into the machine, place
the grab to keep the bale in position, without
overpacking it against the feed rotor.
- Raise the rear end of the machine to keep the
bale inside.
- Raise the arm slightly to decompress the bale
then remove the twine.
Note: It is easier to remove the twine once the bale has been loaded with the twine on the side.