Kongskilde GMT 3205 L P, Руководство оператора

Страница: 84 / 190

6 - WORKING OPERATIONS
Roll pressure
DANGER
Entanglement hazard!
Disengage the Power Take-Off (PTO), turn off
the engine, and remove the key. Wait for all
movement to stop before you leave the oper-
ator's position. Never adjust, lubricate, clean,
or remove a blockage of crop material when
the engine is on.
Failure to comply will result in death or serious
injury.
D0097B
A roll pressure spring (1) on each side of the header con-
trols the resistance of the upper conditioner roll. The eye
bolt
(2) that is connected to the spring allows for roll pres-
sure adjustment.
It may be difficult to determine an optimal setting for roll
pressure.
• In pure grass crops, tighten the springs.
• In clover, alfalfa, or similar leafy crops, loosen the
springs.
Before you start the operation, adjust the roll tension
spring on each side of the header so that approximately
20 mm ( 0.79 in ) of thread (A) is exposed. Adjust the roll
tension during the operation to achieve the desired level
of conditioning.
To adjust the roll pressure, proceed as follows:
1. Install the open-ended fork of the adjustment tool onto
the adjustment nut (3) . Access the adjustment nut
from behind the flotation springs.
2. Use the tool to turn the adjustment nut.
○ Turn the adjustment nut clockwise to increase the
level of conditioning.
○ Turn the adjustment nut counter-clockwise to de-
crease the level of conditioning.
NOTE: Always adjust the roll pressure spring on each side
of the implement equally.
NHIL17HT00503AA
1
6-18