Kongskilde GMT 3205 L P, Руководство оператора

Страница: 105 / 190

6 - WORKING OPERATIONS
You can mount the belt unit in a position lower than stan-
dard. This can be used if you do not want to throw the
crop very far, for example if a double windrow suitable for
a wider pick-up is desired. In the lowest position the belt
unit is fixed to the frame with four bolts placed in the holes
(5) .
NOTE: The length X of the spindles (4) do not change in
the lowest position.
ZEIL18HT00870AA
3
You can mount the belt unit in a position higher than stan-
dard. You can use this position if you want to throw the
crop an extra long way.
NOTE: In this position and under special conditions such
as wet and heavy crop there may be problems throwing
the crop up onto the belt.
In the upper position the frame is fixed to the belt unit with
four bolts placed in the holes shown at
(6) .
NOTE: The length X of the spindles (4) do not change in
the upper position.
When the belt unit is in the upper position, the angle of
the belt unit changes compared to the standard position.
This will cause that the belt moves downward, toward the
front plate.
ZEIL18HT00872FA
4
NOTE: When you move the belt unit to the upper position,
check whether the belt without the load from the crop runs
too close to the back plate of the belt unit. If this is not the
case, adjust the belt as described on Page
7-54 .
6-39