Kollmorgen BDS5, Инструкция по установке и настройке

Страница: 126 / 150

A
PPENDIX
C - E
RROR
C
ODES
BDS5
C-10
The BDS5 encountered an expression in which the number of closing parentheses was not equal to the number of
opening parentheses. This error breaks program execution.
ERROR 96 "SCALING OVERFLOW" SEVERITY 2
During a conversion to or from user units, the result was greater than 231 or less than -231. This error breaks
program execution if the instruction is issued from the user program.
ERROR 97 "GEAR OVERFLOW" SEVERITY 3
The BDS5 encountered an overflow when calculating the velocity from the external pulse input. This can be caused
when the variable GEARI is too small or GEARO is too large. That is, the input times the ratio of GEARO/GEARI
was greater than the highest allowable input frequency, 2 MHz. This error breaks program execution and disables
the BDS5.
C.4.5 Communication Errors
ERROR 103 "BAUD RATE" SEVERITY 1
The variable BAUD contains a value that is not supported by the BDS5. This error occurs during the autobaud
sequence and so is never printed to the terminal. You will only see it in the error history buffer. This error has no
action.
ERROR 104 "ABAUD & MULTIDROP" SEVERITY 1
This error is caused by attempting to autobaud while in multidrop communications, which is not allowed. The
variable ABAUD is on, indicating request for autobaud, and the variable ADDR is not zero, indicating multidrop
communications. This error occurs during the autobaud sequence and so is never printed to the terminal. You will
only see it in the error history buffer. This error has no action.
ERROR 105 "SERIAL WDOG" SEVERITY 3
The serial port did not receive a valid command for WTIME milliseconds when the serial watchdog was enabled
(that is, WATCH = 1). This error breaks program execution and disables the BDS5.
C.4.6 Password Errors
ERROR 110 "EDIT PASSWORD" SEVERITY 1
You attempted to execute an instruction that requires the Editor password. This occurs with the >BDS command. In
this case, you must follow the command with the password.
ERROR 111 "FACTORY SETTABLE" SEVERITY 2
You attempted to change a variable that is protected. These variables are set at the factory. This error breaks
program execution if the instruction is issued from the user program.