Kikusui PFX2532, Руководство по эксплуатации

Страница: 42 / 142

42
PFX2532
Preparing to Connect the DUT (Battery)
1
Using AWG 24 to 20 (0.20 mm
2
to 0.52 mm
2
) cables, construct the following
cable assembly.
2
Solder the thermistor lead to the tip of the temperature sensing cable.
As a guideline, keep the soldering time for the included thermistor less than 7
seconds at no less than 5 mm from the lead root when the soldering iron (50 W)
temperature is 340 °C.
The thermistor does not have polarities.
Be sure to insulate the thermistor lead area with heat-shrinkable insulation tube or the
like.
3
Attach a cover and cable tie to the sensing connector.
Attach a cable tie to the cover to fix the cable firmly in place. Cut the cable tie at an
appropriate length.
If you do not set the connector in the correct orientation, you will not be able to attach
the cover.
4
Attach the top side of the connector cover to the sensing connector.
Firmly insert it until you hear a click.
STRIP-GAUGE
7 mm
Up to 5 m in length
Rear panel
SENSING
connector side
Included
connector plug
1
2
3
4
5
Sensing cable
(2-core shielded cable)
Use this screw to fix the
cables in place so that they
do not come loose.
Remove the first 7 mm of the wire’s covering, and then insert the wire here.
Voltage sensing cable
Temperature sensing cable
Correct Incorrect Incorrect
The wire itself is
in contact with the chassis.
Wire scraps are
in contact with the chassis.
Heat-shrinkable insulation tube
or insulation tape
Solder
Thermistor
Shield potential
Temperature sensing cable
Heat-shrinkable insulation tube
or insulation tape
Solder
Thermistor
Tab
Screw side on top