30
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tools Required
•
Phillips Screwdriver
•
Level
1. Set the peninsula worksurface
face down onto a soft
protective surface. Attach the
single leg to the peninsula
worksurface with four #12 x 1”
screws (Figure 1).
2. Position the center mount
modesty panel onto the
peninsula, over the modesty
panel mounting holes.
Attach the modesty panel to
peninsula with two #12 x 1”
screws (Figure 1).
3. Secure two splice plates to
the mounting holes at the
underside of each adjoining
rectangular worksurface. Use
two #12 x 1” screws per splice
plate (Figure 2).
Note:
Transitional leg sets can
be identified by their shorter,
floor-level foot, for less
restricted user movement.
4. Carefully turn the peninsula
worksurface right side up. Set
the peninsula worksurface into
position on the splice plates.
Align the mounting holes and
secure the peninsula to the
worksurface from underneath
with eight #12 x 1” screws,
two per splice plate (Figure 2).
5. Attach the modesty panel of the
peninsula worksurface to the
transitional legs with two
#10 x ½” screws per side of
the center mount modesty
panel (Figure 2).
6. Level the peninsula
worksurface by turning the
adjustable glide on the single
leg either in or out (Figure 1).
WorkZone
®
Peninsula Worksurface - Center Mounting
Assembly Instructions
#12 x 1" screw
#10 x ½" screw
Tools Required
Note:
Phillips Screwdriver
Level
1. Set the peninsula worksurface face down
onto a soft protective surface. Attach the
single leg to the peninsula worksurface with
four #12 x 1” screws (Figure 1).
2. Position the center-mounted modesty
panel onto the peninsula, over the modesty
panel mounting holes. Attach the modesty
panel to peninsula with two #12 x 1”
screws (Figure 1).
3. Secure two splice plates to the mounting
holes at the underside of each adjoining
rectangular worksurface. Use two #12 x 1”
screws per splice plate (Figure 2).
Transitional leg sets can be identified
by their shorter, floor-level foot, for less
restricted user movement.
4. Carefully turn the peninsula worksurface
right side up. Set the peninsula worksurface
into position on the splice plates. Align the
mounting holes and secure the peninsula to
the worksurface from underneath with eight
#12 x 1” screws, two per splice plate
(Figure 2).
5. Attach the modesty panel of the peninsula
worksurface to the transitional legs with two
#10 x ½” screws per side of the center
mount modesty panel (Figure 2).
6. Level the peninsula worksurface by
turning the adjustable glide on the single leg
either in or out (Figure 1).
#12 x 1" screw
#10 x / " screw
1
2
WorkZone Peninsula Worksurface
Center Mounting
Assembly Instructions
#12 x 1"
screw
#12 x 1"
screw
#12 x 1"
screw
transitional
leg set
transitional
leg
splice
plate
splice
plate
leg
leveler
single
leg
center mount
modesty panel
#10 x / "
screws
1
2
peninsula
worksurface
peninsula
worksurface
adjoining
rectangular
worksurface
adjoining
rectangular
worksurface
Figure 1
Figure 2
Figure 1
Figure 2
adjustable
glide
