Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
7
Finisher to Starter/Adder
Assembly
13. Carefullly turn the finisher
worksurface assembly to the
upright position and set the
no-leg end of the adder surface
onto the shared-leg bracket of
the adder worksurface assembly
(Figure 5).
14. Twist in four #12 x 1” screws
through the shared-leg bracket
of the adder worksurface, and
into the pre-drilled mounting
holes at the underside of
the finisher worksurface as
illustrated. Do not tighten
screws completely at this time
(Figure 5).
WorkZone
®
Starter/Adder/Finisher Worksurface
Assembly Instructions
15. Twist in two #10 x ½” screws
through the side of the adder
modesty panel and into the leg
of the starter worksurface, but do
not tighten screws at this time
(Figure 5).
16. Align the run of adjoining tables
to their final location and twist
leveling glides in or out to level
worksurfaces properly. The
jambnuts between the glides
and the bottom of the leg sets
must be tightened up against
the bottom of the leg to secure
the glide. At this time, tighten all
screws attaching modesty panels
to legs and shared-leg brackets
to worksurfaces
(Figure 5).
Figure 5 - Finisher to Adder/Starter Assembly
Figure 5- Finisher to Adder/Starter Assembly
finisher
worksurface
assembly
starter
worksurface
assembly
adder
worksurface
assembly
shared-leg
bracket
transitional leg set
(shorter foot)
#12 x 1”
screw
#10 x ½”
screw
finisher
modesty panel
standard
leg set
adjustable
glides
adjustable
glides
standard
leg set
Finisher to Starter/Adder Assembly
11.Carefullly turn the finisher
worksurface assembly to the upright
position and set the no-leg end of the
adder surface onto the shared-leg
bracket of the adder worksurface
assembly (Figure 5).
12. Twist in four #12 x 1” screws
through the shared-leg bracket of the
adder worksurface, and into the pre-
drilled mounting holes at the underside of
the finisher worksurface as illustrated.
Do not tighten screws completely at this
time (Figure 5).
13. Twist in two #10 x ½” screws
through the side of the adder modesty
panel and into the leg of the starter
worksurface, but do not tighten screws
at this time (Figure 5).
14. Align the run of adjoining tables to
their final location and twist leveling
glides in or out to level worksurfaces
properly. The jambnuts between the
glides and the bottom of the leg sets
must be tightened up against the bottom
of the leg to secure the glide. At this time,
tighten all screws attaching modesty
panels to legs and shared-leg brackets to
worksurfaces (Figure 5).
Starter/Adder/Finisher Worksurface Assembly
Figure 5 - Finisher to Adder/Starter Assembly
