Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
3. Align modesty panel between
leg sets. If optional horizontal
wireway is to be installed to
unit, place the wireway between
mounting flange of modesty panel
and the worksurface, aligning the
mounting holes as illustrated.
Insert two #10 x ½” screws per
left and right side of modesty
panel into leg. Do not tighten at
this time (Figure 1).
4. Carefully stand the worksurface
right side up and install two leg
plugs into the two exposed holes
at the outside of each leg set as
illustrated (Figure 2).
Note:
Two different vertical
wireway halves are supplied with
non-powered tables: The “vertical
wireway - inner” (with two
cut-outs) is to be installed
facing the inside of the table.
The “vertical wireway-outer” (no
cut-out) is to be installed on the
outside of a leg (Figure 2).
5. Vertical wireways fasten into
each other from each side of
the leg set opening and must
be oriented to press together.
Begin by positioning an outer
vertical wireway (no-cut-out),
to the outside of the leg set as
illustrated. Next position the inner
vertical wireway cover (two
cut-outs) in the correct
orientation at the inside of the
leg set and press it into the outer
wireway (Figure 2).
6. Level the worksurface by turning
the four adjustable glides either
in or out. The jambnuts between
the glides and the bottom of the
leg sets must be tightened up
against the bottom of the leg to
secure the glide (Figure 2).
7. Press worksurface grommets into
wireway holes in worksurface top
(Figure 2).
WorkZone
®
Basic Worksurface
Assembly Instructions
3. Align modesty panel between leg sets.
If optional horizontal wireway is to be
installed to unit, place the wireway
between mounting flange of modesty
panel and the worksurface, aligning the
mounting holes as illustrated. Insert two
#10 x ½” screws per left and right side
of modesty panel into leg. Do not tighten
at this time (Figure 1).
Two different vertical wireway
halves are supplied with non-powered
tables: The “vertical wireway - inner”
(with two cut-outs) is to be installed
facing the inside of the table. The
“vertical wireway-outer” (no cut-out) is
to be installed on the outside of a leg
(Figure 2).
5. Vertical wireways fasten into each
other from each side of the leg set
opening and must be oriented to press
together. Begin by positioning an outer
vertical wireway (no-cut-out), to the
outside of the leg set as illustrated. Next
position the inner vertical wireway cover
(two cut-outs) in the correct orientation at
the inside of the leg set and press it into
the outer wireway (Figure 2).
Note:
4. Carefully stand the worksurface right
side up and install two leg plugs into the
two exposed holes at the outside of each
leg set as illustrated (Figure 2).
6. Level the worksurface by turning the
four adjustable glides either in or out. The
jambnuts between the glides and the
bottom of the leg sets must be tightened
up against the bottom of the leg to secure
the glide (Figure 2).
7. Press worksurface grommet cover into
wireway holes in worksurface top
(Figure 2).
Figure 2
WorkZone Basic Worksurface / Printer Stand
leg plug
vertical
wireway - outer
vertical
wireway - inner
leg set
adjustable
glide
worksurface
grommet cover
Figure 2
