Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
27
WorkZone
®
Transitional Worksurface - Square/Rectangular Surface
Assembly Instructions
5. Position the primary and return
work surfaces as illustrated,
set the square or rectangular
transitional surface onto the
splice plates, and attach the
transitional surface to the splice
plates with eight #12 x 1”
screws, two per splice plate from
underneath (Figure 3).
6. Align the modesty panel mounting
holes of the transitional surface
to the transitional leg sets of the
primary and return worksurfaces,
then secure together using two
#10 x ½” screws per modesty
panel and leg set (Figure 3).
7. To level the worksurfaces, turn the
adjustable glides either in or out.
The jambnuts between the
adjustable glides and the bottom
of the leg sets must be tightened
up against the bottom of the leg
to secure the adjustable glides.
Note:
In a step down installation,
use a Z-bracket (not shown)
instead of splice plates.
Z-brackets are installed in the
same manner as splice plates.
return
worksurface
primary
worksurface
transitional
leg set
#12 x 1"
screw
#10 x ½"
screw
modesty panel
splice plate
Figure 3
square/rectangular
transitional
surface
Figure 3
