2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tools Required
•
Phillips Screwdriver
•
Level
1. To avoid scratching the
worksurface, place the top face
down onto a soft protective
surface.
2. Attach two leg sets to
worksurface bottom by
aligning legs to pre-drilled
holes and inserting three
#12 x 1
3
/
4
” screws per leg set
(Figure 1).
Note:
In the instance where
a worksurface is to be paired
with a transitional unit, a leg
set with a short transitional
foot (not shown) will be
assembled to the end of
the worksurface where the
transitional unit is to be
attached. Refer to your
space-planning layout.
Important:
Worksurfaces are
assembled upside-down, so
will be in reverse orientation
as compared to your
space-planning layout.
WorkZone
®
Basic Worksurface
Assembly Instructions
Figure 1
