Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
31
Tools Required
•
Phillips Screwdriver
•
Level
Note:
Read through all
instructions completely before
beginning assembly.
End-mount peninsula assembly
has two types of installation
depending upon if the peninsula
worksurface attaches to the side
of a rectangular worksurface
(Figure 2) or the front edge of the
worksurface (Figure 3).
1. Set the peninsula worksurface
face down onto a soft protective
surface. Attach the single leg to
the peninsula worksurface with
four #12 x 1” screws (Figure 1).
Note:
End-mount peninsula
worksurfaces that attach to
the front edge of the adjoining
rectangular worksurface
(Figure 3) requires a reverse in
assembly procedure. Refer to
steps 2 and 3 but install the two
splice plates to the peninsula
worksurface first, instead
of the adjoining rectangular
worksurface. Also, the peninsula
worksurface must be positioned
up into place with splice plates
installed, so marks can be made
through the splice mounting
holes and onto the underside, at
the front edge of the adjoining
worksurface. The four holes must
be carefully drilled to a depth of
1” then the peninsula worksurface
can be installed to the rectangular
worksurface (Figure 3).
WorkZone
®
Peninsula Worksurface - End Mounting
Assembly Instructions
#12 x 1" screw
#10 x / " screw
1
2
Tools Required
Note:
Note:
Phillips Screwdriver
Level
Read through all instructions
completely before beginning assembly.
End-mount peninsula assembly has two
types of installation depending upon if the
peninsula worksurface attaches to the side
of a rectangular worksurface (Figure 2) or
the front edge of the worksurface (Figure 3).
1. Set the peninsula worksurface face down
onto a soft protective surface. Attach the
single leg to the peninsula worksurface with
four #12 x 1” screws (Figure 1).
End-mount peninsula worksurfaces
that attach to the front edge of the adjoining
rectangular worksurface (Figure 3) requires
a reverse in assembly procedure. Refer to
steps 2 and 3 but install the two splice plates
to the peninsula worksurface first, instead of
the adjoining rectangular worksurface. Also,
the peninsula worksurface must be
positioned up into place with splice plates
installed, so marks can be made through the
splice mounting holes and onto the
underside, at the front edge of the adjoining
worksurface. The four holes must be
carefully drilled to a depth of 1” then the
peninsula worksurface can be installed to
the rectangular worksurface (Figure 3).
#12 x 1" screw
#10 x ½" screw
WorkZone Peninsula Worksurface
End Mounting
Assembly Instructions
#12 x 1"
screw
leg
leveler
single
leg
peninsula
worksurface
Figure 1
Figure 1
