20
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tools Required
•
Phillips Screwdriver
•
Level
Note:
The corner transitional
worksurface is not illustrated
but is assembled in the same
manner as the keyboard pad
corner transitional.
1. Attach two-splice plates to the
primary worksurface with two
#12 x 1” screws per splice
plate. Repeat the procedure
for splice plates to the return
surface (Figure 1).
2. To avoid scratching the
transitional worksurface, place
the top face down onto a soft
protective surface (Figure 2).
3. Position the corner leg over the
pre-drilled holes in the back
corner of the worksurface.
Be sure the modesty panel
mounting holes are oriented as
shown. Attach the corner leg to
the worksurface with four
#12 x 1” screws. Do not
tighten at this time (Figure 2).
WorkZone
®
Transitional Worksurface - Keyboard Pad & Corner
Assembly Instructions
#12 x 1" screw
#10 x / " screw
1
2
#12 x ½” Carriage bolt, washer and adjustment knob
Tools Required
Note:
Phillips Screwdriver
Level
The standard corner transitional
worksurfaces is not illustrated but is
assembled in the same manner as the
keyboard pad corner transitional.
1. Attach two-splice plates to the primary
worksurface with two #12 x 1” screws per
splice plate. Repeat the procedure for splice
plates to the return surface (Figure 1).
2. To avoid scratching the transitional
worksurface, place the top face down onto a
soft protective surface (Figure 2).
3. Position the corner leg over the pre-drilled
holes in the back corner of the worksurface.
Orient the corner leg so the other four holes
of the corner leg face inward to attach the
modesty panels in a later step. Attach the
corner leg to the worksurface with four
#12 x 1” screws. Do not tighten at this time
(Figure 2).
#12 x 1" screw
#10 x / " screw
1
2
#12 x ½” Carriage bolt, washer and adjustment knob
WorkZone Transitional Worksurface
Keyboard Pad & Corner
Assembly Instructions
primary
worksurface
return
worksurface
#12 x 1"
screw
splice
plates
adjustable
glide
corner leg
#12 x 1" screw
#12 x 1"
screw
horizontal wireway
(optional)
#10 x / " screw
1
2
modesty panel
modesty panel
Figure 2
Figure 1
Figure 1
Figure 2
corner
transitional
worksurface
