KI Tattoo Flex Screen, Руководство по сборке

Страница: 36 / 52

36
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen Trim
Assembly Instructions
In-Line Spacer Installation with
Flex Screen Intersection (cont.)
Note: Two different top caps are
available for Tattoo Screen spacers
and are labeled so on the bottom
of each top cap. An “E” or “I”
is displayed on each top cap to
represent if the cap is for end-of-run
or in-line. As labeled, the top caps
are designed to install to a specific
spacer. Take care and follow the
directions below when installing the
top cap. If top cap is not installed to
the proper spacer, the flat aluminum
top cap will not fit correctly,
extending too far and disassembly
and reassembly will be required.
6. Confirm the spacer top cap is
labelled “I” on the underside for
inline. Place the top cap onto the
spacer. Align the mounting hole
on the side of the top cap with the
mounting hole in the spacer
cover channel and secure with a
#10-24 x
1
/
2
” Phillips flat head
screw. The spacer top cap will rest
flush with the flat aluminum top cap
installed in a later step (Figure 40
& Detail AAA).
Note: Each powered Spine Screen
has two 10-wire rigid wireways that
are pre-mounted in the base raceway
at the factory.
Note: Spine Screen electrical is
“in-line” only and does not turn
corners. Spine Screens cannot pass
power to Flex Screens.
Spine
Screen
(#2)
Spine
Screen
(#1)
Flex
Screen
spacer
top cap
(in-line)
spacer
(in-line)
#10-24 x / ”
Phillips flat
head screw
1
2
Figure 40
Spine
Screen
(#2)
Spine
Screen
(#1)
#10-24 x / ”
Phillips flat
head screw
1
2
spacer
(in-line)
spacer
top cap
(in-line)
Detail AAA