KI Tattoo Flex Screen, Руководство по сборке

Страница: 18 / 52

18
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen 10-Wire Power
Assembly Instructions
10-Wire Top Power Infeed
(In-Line) Installation with Flex
Screen Intersection (cont.)
Note: Each powered Spine Screen
has two 10-wire rigid wireways
that are pre-mounted in the base
raceway at the factory.
Note: Spine Screen electrical is
“in-line” only and does not turn
corners. Spine Screens cannot pass
power to Flex Screens.
8. Determine the length of both
vertical trim by measuring the
distance from the ceiling to the top
of the Spine Screen frame. Cut the
vertical trim to the marked lengths
(Figure 14).
9. On the rib side of the vertical trim,
space molding clips evenly apart
and press them onto the ribs of the
vertical trim as illustrated
(Figure 14 & Detail W).
10. Place the 10-wire top infeed
conduit inside the power pole and
route the plug end of the infeed
down through the pass-through
ankle and plug it into the end of the
10-wire rigid wireway (Figure 14).
11. Push the 10-wire end of the
power infeed up and through the
top of the power pole and into
the above-ceiling area for later
connection to the source power (by
a certified electrician)(Figure 14).
12. Determine the length of the
top infeed power pole cover by
measuring the distance from the
ceiling to the floor at the side of the
infeed power pole. Cut the cover
square to the marked length
(Figure 14).
13. On the rib side of the power pole
cover, space molding clips evenly
apart and press them onto both ribs
on the cover (Figure 14 & Detail X).
14. Position the power pole cover
with molding clips up against the
opening side of the end-of-run
top infeed power pole. Using a
firm hand, press on the trim at the
molding clip locations to snap
into the power pole cover channel
(Figure 14 & Detail X).
15. Reference “Leveling and
Connecting Spine Screens”
instructions on page 6 to connect
remaining screens.
screen-to-screen
10-wire jumper
(21 / ”)
1
4
power
pole cover
vertical
trim
vertical
trim
10-wire top
power infeed
exposed
10-wires
top infeed
power pole
(in-line)
pass-through
ankles
Spine
Screen
(#2)
Spine
Screen
(#1)
molding
clip
molding
clips
Flex
Screen
10-wire
rigid wireway
Figure 14
Detail W
outer
vertical
trim
molding
clip
vertical
power pole
channel
Detail X
power pole
cover
power pole
cover
channel
molding
clip
power pole
cover
channel