KI Tattoo Flex Screen, Руководство по сборке

Страница: 23 / 52

23
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen 10-Wire Power
Assembly Instructions
6. On the rib side of the base infeed
trim, space molding clips evenly
apart and press them onto the ribs of
the trim (Figure 23 & Detail GG).
7. Position the base infeed trim with
molding clips up against the base
infeed spacer with the 10-wire infeed
routed through the opening at the
bottom of the infeed trim. Using a
firm hand, press to snap molding
clips of the base infeed trim into the
vertical spacer channel (Figure 23 &
Detail GG).
8. On the rib side of the base infeed
spacer cover, space molding clips
evenly apart and press them onto
both ribs on the cover (Figure 23 &
Detail HH).
9. Position the base infeed space cover
with molding clips up against the
base infeed spacer. Using a firm
hand, press to snap molding clips
of the spacer cover into the spacer
cover channel (Figure 23 &
Detail HH).
Figure 23
Spine
Screen
base infeed trim
(end-of-run)
molding
clip
vertical
spacer
channel
space cover
channel
spacer
cover
10-wire base
power infeed
base
infeed spacer
(end-of-run)
Detail GG
vertical
spacer
channel
molding
clip
base infeed
trim
Detail HH
spacer
cover
molding
clip
spacer cover
channel