KI Tattoo Flex Screen, Руководство по сборке

Страница: 7 / 52

7
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen Leveling & Connecting
Assembly Instructions
6. Ensure that the two in-line Spine
Screens to be joined are tight to each
other and properly aligned plumb
and level. If screens are not plumb
and level to each other, reference
“Leveling & Connecting Spine
Screens” instructions on page 6.
7. At the location where two in-line
screens will be joined at the top,
place a connector plate over the
notch in both horizontal frames.
Bridge the frames with the connector
plate and align the four mounting
holes in the screens with the
mounting holes in the connector
plate. Secure the plate to the screen’s
horizontal frame using four
#10-24 x
3
/
8
” Torx screws
(Figure 3 & Detail E).
Note: Do not install any trim at this
time. Trim is last to be installed, at a
later time.
Figure 3
Spine Screen
Spine Screen
connector
plate
#10-24 x / ”
Torx screws
3
8
horizontal
frame
horizontal
frame
Detail E
Spine Screen
Spine Screen
connector
plate
horizontal
frame
#10-24 x / ”
Torx screws
3
8