KI Tattoo Flex Screen, Руководство по сборке

Страница: 12 / 52

12
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen 10-Wire Power
Assembly Instructions
10-Wire Top Power Infeed
(End-of-Run) Installation
Note: If the Spine Screen System
is to be installed with New York
City electrical, reference the Tattoo
Screen System - New York City
Electrical Assembly Instructions
(KI-AI-000045), and proceed to the
"New York City Infeed Electrical Box"
instructions on page 4.
Note: The power infeeds are to be
connected to the power source by
a qualified electrician who must
follow all state and local codes at the
building site and check the electrical
integrity of the finished system.
Note: All screens must be
mechanically connected together,
with all 10-wire rigid wireways and
screen-to-screen power connections
appropriately installed before adding
power infeed, or connecting infeed to
power source.
1. Per the space-planning layout,
determine the location for top power
infeed. Make sure the screen to
receive top power infeed is at its final
location, and is plumb and level.
2. At the ceiling, directly above the
location where the end-of-run top
infeed power pole will connect to
the Spine Screen end, drop a plumb
line from the ceiling, down to one
top, end corner of the Spine Screen,
then mark that location at the ceiling.
At the mark on the ceiling, carefully
mark and cut a rectangular hole
through the ceiling at 3
3
/
8
x 3”, as
illustrated for the power pole to go
through at a later step (Figure 8).
3. Measure from the ceiling, down
to the floor at the end of the
Spine Screen, then add 4” to that
measurement for required power
pole length. Take the top infeed
power pole in hand and transfer
that measurement to the top of the
pole, then squarely cut the top of the
power pole off to that measurement
(Figure 8).
Note: If a power pole extension
is needed for the top infeed power
pole to reach the ceiling, it must be
installed before installing the screen
connectors. Reference “Power Pole
Extension Installation” instructions
on page 19, then return to step 4 on
this page.
4. The screen connector comes with
eight molding clips installed (shown
uninstalled, Figure 8), four on each
side. Position the screen connector
up against the vertical frame channel
of the Spine Screen, with clips
oriented as shown. Using a firm
hand, press at the molding clips, on
the screen connector one at a time
to seat them into the vertical frame
channel at the end of the Spine
Screen (Figure 8 & Detail N).
5. Position the end-of-run top infeed
power pole, with the side opening
to the desired side of the screen,
and orient the top, cut end facing
upward. Route the top of the power
pole carefully up through the cut-out
in the ceiling while pressing the side
toward the screen connector/clips
in the vertical frame channel of the
screen. Let the bottom of the power
pole rest on the ground, then press
forcefully from inside the power pole
at the side, to engage all molding
clips of the screen connector into
the vertical channel of the top infeed
power pole (Figure 8 & Detail N).
Figure 8
Spine
Screen
screen
connector
ceiling
cutout top infeed
power pole
(end-of-run)
molding
clips
vertical
power pole
channel
screen
connector
molding clip
(factory installed)
Spine
Screen
vertical
frame
channel
top infeed
power pole
(end-of-run)
Detail N