KI Tattoo Flex Screen, Руководство по сборке

Страница: 8 / 52

8
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen Leveling & Connecting
Assembly Instructions
Spine Screen
(48” high shown)
Spine Screen
(54” high shown)
height-adjustable
glides (adjusted for
panels to be in the
lowest position)
height-adjustable glide
(adjusted for the
panel to be in the
lowest position)
laser
alignment
tool
Figure 4
molding
clips
screen
connector
Detail F - Side View of Screen
height-adjustable
glide (adjusted for
the screen to be
in the lowest
position)
base
raceway
trim
Note: Adjust the height of each screen
to the lowest position by rotating the
height-adjustable glides clockwise.
Detail G
screen
connector
molding clip
(come installed
from factory)
vertical
frame
channel
Detail H
Spine
Screen
Spine
Screen
Leveling & Connecting
Change-of-Height Spine Screens
Note: A single Spine Screen may
not be used as a freestanding screen
on its own. The Spine Screen must
always be mechanically attached
to another Spine Screen (with or
without electrical).
Important: Know and mark all high
and low spots on the floor. Make sure
to twist adjustable glides appropriate
to floor conditions. Always begin
assembling screens together at the
highest point of an un-even floor.
1. Using a laser alignment tool,
determine and mark all high and
low points on the floor. Adjust the
level and height of the Spine Screen,
beginning at the highest point in
the floor first. To raise the screen,
rotate the glide counter-clockwise.
To lower the screen, rotate the screw
clockwise. Only extend the glides as
needed to make the screen level and
plumb (Figure 4 & Detail F).
2. Locate the screen connector
(Detail G) and take note that it
contains eight molding clips
installed, four at each side. Figure 4
shows the molding clips separated
for clarity. Each clip will press-fit into
the appropriate screen’s channel to
help join screens together. Assure
that the first Spine Screen is level
and plumb, and at its final installation
location. Position the bottom screen
connector up to the bottom of the
vertical channel of the first Spine
Screen and firmly press it in, oriented
as shown (Figure 4 & Detail G).
3. Position the second Spine Screen
in-line against the first Spine Screen,
which has been adjusted level
and plumb. Level and plumb the
second screen to the first screen by
twisting the height-adjustable glides
clockwise or counter-clockwise until
the frame’s vertical edges are aligned.
Connect the screens together by
holding the first Spine Screen in
place while pressing firmly on the
second, into the first so the screen
connector in the first engages the
second screen (Figure 4 & Detail H).
4. Repeat the process in steps 2 & 3 to
add, level, plumb and connect the
remaining change-of-height screens
in the row. If the remaining screens
to be connected are the same height,
go now to “Leveling & Connecting
Spine Screens” instructions on
page 6, step 4.