KI Tattoo Flex Screen, Руководство по сборке

Страница: 19 / 52

19
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Wide Screens - Spine Screen 10-Wire Power
Assembly Instructions
Power Pole Extension Installation
Note: The power pole extension is
specified for ceilings higher than
10’, and must be added to the top
infeed power pole prior to installing
the pole to the Spine Screen(s). The
Spine Screen(s) to receive the power
pole with extension must be at their
final installation location.
1. Assure that the Spine Screen(s) to
receive the power pole with extension
are at their final installation location,
the hole is cut in the ceiling as
specified earlier (pages 12, 14 & 16),
then measure from the ceiling to the
floor at the end of a screen which
will receive the extended pole. The
top infeed power pole is 122” long,
so subtract 122” from the floor to
ceiling measurement, then add 4” for
the length to cut the extension pole
to. Take the power pole extension in
hand, transfer the required length
measurement to it and squarely cut
the extension pole to size such that
it can project 4” above ceiling height
when installed.
2. As illustrated, align the open side
of the power pole extension bracket
with the open side at the top of the
top infeed power pole, and slide the
extension bracket into the power
pole, aligning the mounting holes
of both. Insert four #10-24 x
1
/
2
”
Phillips flat head screws through
the power pole and bracket at four
mounting locations, then add #10-24
lock nuts and tighten (Figure 15 &
Detail Y).
3. Orient the cut-off end of the pole
extension away from the power
pole’s installed extension bracket.
With the opened side of the power
pole extension facing in the same
direction as the installed power pole
extension bracket opening, slide
the extension pole onto the power
pole extension bracket, aligning the
mounting holes of both (Figure 16 &
Detail Z).
4. Insert four #10-24 x
1
/
2
” Phillips
flat head screws through the power
pole extension and bracket at four
mounting locations, then add #10-24
lock nuts and tighten (Figure 16 &
Detail Z).
Reference “10-Wire Top Power
Infeed (End-of-Run) Installation”
instructions on page 12, step 4,
“10-Wire Top Power Infeed (In-Line)
Installation” instructions on
page 14, step 4, or “10-Wire Top
Power Infeed (In-Line) Installation
with Flex Screen Intersection”
instructions on page 16, step 4
to finish top infeed power pole
installation.
Figure 15
power pole
extension
bracket
top infeed
power pole
Figure 16
power pole
extension
bracket
top infeed
power pole
power pole
extension
Detail Y
#10-24
lock nuts
#10-24 x / ”
Phillips flat
head screw
1
2
power pole
extension
bracket
#10-24 x / ”
Phillips flat
head screw
1
2
vertical
power pole
channel
Detail Z
#10-24
lock nuts
#10-24 x / ”
Phillips flat
head screw
1
2
vertical power
pole channel
power pole
extension
top infeed
power pole
power pole
extension
bracket