KI Tattoo Flex Screen, Руководство по сборке

Страница: 21 / 52

21
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™ Screens - Spine Screen 10-Wire Power
Assembly Instructions
Detail AA
10-wire
rigid wireway
mounting
plate
base infeed
adapter receptacle
Detail BB
inner socket
of 10-wire
rigid wireway
base infeed
adapter receptacle
Detail CC
wedges on
adapter
catch
clip
base infeed
adapter receptacle
Spine
Screen
base infeed
adapter receptacle
10-wire
rigid wireway
mounting
plate
Figure 19
Spine
Screen
base infeed
adapter
receptacle
180°
base
raceway
trim
base raceway
power infeed
base power
infeed shroud
shroud
screw
lock bar
lock
bar
Figure 20
base
trim lip
Detail DD
base
raceway
trim
bottom
wireway
channel
base infeed
adapter
receptacle
base raceway
power infeed
base power
infeed shroud
lock
bar
shroud
screw
Detail EE
Base Raceway Power Infeed
Installation
1. Position the base infeed adapter
receptacle on the end of the 10-wire
rigid wireway where the base power
infeed is received, matching the
arrow at the “N” symbol facing up
(Figure 19 & Detail AA).
2. Align the adapter so the end is
in-line with the inner socket on the
rigid wireway and push the adapter
back against the mounting plate
(Detail AA).
3. Slide the adapter receptacle to
the side and snap it into the rigid
wireway’s inner socket (Detail BB).
4. Adapter is properly seated when the
catch clip on the wireway is snapped
in between the wedges on the
receptacle (Detail CC).
5. Install the base raceway trim by
engaging the base trim lip with the
bottom wireway channel (Detail DD).
6. Pull up the lock bar on the plug end
of the base raceway power infeed.
The base infeed can be rotated 180°
and installed in one of two directions.
Orient the lock bar to be up, then
press the base raceway power infeed
to the adapter receptacle in the
desired direction. Press down to
snap and secure the lock bar onto
the base infeed adapter receptacle
on the power infeed, then place the
base infeed shroud over the infeed
and secure with the shroud screw
provided (Figure 20 & Detail EE).