Keysight Technologies AC6801B, Руководство по эксплуатации и обслуживанию

Страница: 7 / 197

General Warnings
Do not use this product in any manner not specified by the manufacturer. The protective
features of this product may be impaired if it is used in a manner not specified in the
operation instructions.
Instruments that appear damaged or defective should be made inoperative and secured
against unintended operation until they can be repaired by qualified service personnel.
The instrument contains an internal fuse, which is not user accessible.
DO NOT REMOVE COVERS. NO OPERATOR SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
SECURELY TURN OFF THE CIRCUIT BREAKER ON THE SWITCHBOARD BEFORE
HANDLING THE POWER CORDS. TO AVOID AN ELECTRIC SHOCK, THE PROTECTIVE
CONDUCTOR TERMINAL MUST BE CONNECTED TO AN ELECTRICAL GROUND.
NE PAS RETIRER LES COUVERTURE DE LA BOITE. AUCUN OPÉRATEUR SERVICEABLE
PIÈCES À L'INTÉRIEUR. CONFIER L'ENTRETIEN DE PERSONNEL QUALIFIÉ.
CORRECTEMENT COUPER LE DISJONCTEUR ARMOIRE AVANT DE MANIPULER LES
CORDONS D'ALIMENTATION. POUR ÉVITER TOUT CHOC ÉLECTRIQUE, LE
CONDUCTEUR DE PROTECTION BORNE DOIT ÊTRE RELIÉE À UNE MASSE ÉLECTRIQUE.
Environmental Warnings
This product is designed for safe indoor use. Use indoors only.
Do not operate the instrument near flammable gases or fumes.
To prevent the possibility of explosion or fire, do not use the product near alcohol, thinner
or other combustible materials, or in an atmosphere containing such vapors.
Do not install the product near a heater, in direct sunlight, or in areas subject to drastic
temperature changes. The operating temperature range is 0 to 40 °C (32 to 104 °F), and
the storage temperature range is -10 to 60 °C (14 to 140 °F).
Do not install the product in high-humidity locations, such as near a boiler, humidifier, or
water supply. The operating humidity range is 20% to 80% relative humidity (no
condensation), and the storage humidity range is 90% relative humidity or less (no
condensation). Condensation may occur even within the operating humidity range. In
such cases, do not use the instrument until the condensation dries up completely.
Do not install the product in a corrosive atmosphere or in environments containing
sulfuric acid mist, etc. This may cause corrosion of various conductors and bad contacts of
connectors inside the instrument leading to malfunction and failure, or in the worst case,
a fire.
Do not install the product in a dusty location. Accumulation of dust can lead to electric
shock or fire.
Keysight AC6800B Series Operating and Service Guide 7
Safety and Regulatory Information