Series 2600 System SourceMeters Reference Manual
Getting Started 1-15
Return to
2600S-901-01 Rev. A / May 2006
Beeper
With the beeper enabled, a beep will be issued to acknowledge the following
actions:
• A short beep, emulating a keyclick, is issued when a front panel key is
pressed.
• A short beep is also issued when the rotary knob is turned or pressed.
• A longer beep is issued when the source output is turned on.
To control the beeper from the front panel, select MENU > GENERAL > BEEPER,
then ENABLE or DISABLE the beeper as desired.
Via remote, use the
beeper.enable
command to control the beeper. For
example, the following enables the beeper:
beeper.enable = 1
Display modes
Use the DISPLAY key to cycle through the various display modes shown in
. For the Models 2602 and 2612 only, pressing DISPLAY cycles
between the dual-channel display mode and single-channel modes for CHANNEL
A (SMU A) and CHANNEL B (SMU B). The Models 2601 and 2611 have only one
channel (SMU A). The User State display messages are defined with specific
display commands (refer to
for more information on display messag-
ing).
Содержание SourceMeter 2600 Series
Страница 507: ...AppendixA Specifications Appendix A topics Model 2600S Specifications page A 2 2600S 901 01 Rev A May 2006...
Страница 575: ...AppendixF DisplayCharacterCodes Appendix F topics Introduction page F 2...
Страница 592: ......
Страница 593: ......