118 from 176
You can use this function to allow you to operate several receivers (e.g. four UFS 906
units) using the same remote control. You can assign each receiver its own remote
control code. The prerequisite for this is that the receiver was supplied with a remote
control from the RC 67x series or with the RC 660 remote control, e.g. of the UFS 902.
15
Mainmenu - Settings
You can now use the remote control for your receiver to set a new remote control code
(the remote control code 1 is set as standard). Press the following buttons simultaneously:
►
+
+
for remote control code 1
►
+
+
for remote control code 2
►
+
+
for remote control code 3
►
+
+
for remote control code 4
Now press the
button. If the receiver does not close the on-screen display, the receiver
and the remote control are not set to the same remote control code. Check your setting again.
To set the remote control for whichever remote control code is required in future, proceed as
follows:
►
+
for remote control code 1
►
+
for remote control code 2
►
+
for remote control code 3
►
+
for remote control code 4
If you have another Kathrein receiver in use that was supplied with the RC 660 remote
control, you can use the UFS 906 remote control to operate that other receiver also.
On the UFS 906 remote control, the codes for remotely controlling the RC 660 begin
with "5":
+
= Remote control code 1 for RC 660
+
= Remote control code 2 for RC 660
+
= Remote control code 3 for RC 660
+
= Remote control code 4 for RC 660
Tip!
