9
The information in this operating manual was correct at the time of going to print. We reserve the right
however to make changes at any time and without prior notice. If new software is released for your
receiver, and this affects the information in the operating instructions (e.g. changes to the menus and/or
functions), if we believe it necessary we will make available new operating instructions for download at
“www.kathrein.de”.
Make a note of the receiver's basic settings (these are set during the
fi
rst installation), so you can restore
them if necessary!
Please be aware of your responsibility towards your fellow human beings! Keep this manual
for any questions that arise later, and if the receiver passes to another owner, pass it on to the
new owner.
For compliance with the EMC Directives, the USB connection cable between the receiver and hard disk
must not be longer than 50 cm.
Please see the UFS 913 Operating manual – Part 1, “Connection and set-up” for details on how to
connect the receiver and carry out
fi
rst installation.
The following description of the menus and functions assumes that the UFS 913 has been correctly
connected and installed (as detailed in the operating instructions part 1 “Connection and set-up”).
Miscellaneous
Safety Instructions - Important Notes
Network function
To connect the receiver to the network via the PC/laptop, you must have unrestricted rights (administrator
rights) for your PC/laptop and on your network. For this refer to the chapter “Main Menu”, “Interfaces”,
“Network Settings”.
Power consumption in standby mode < 0.5 W
The standby power consumption of < 0.5 W printed on the receiver packaging will only be achieved when
the receiver is in standby mode with the display switched off. You can de
fi
ne this setting in the following
menu: “Main menu”, “Settings”, “User-De
fi
ned Settings”, “Customize Screen Menu”, “Front display
in standby”
→
Setting “Off”.
