8
Product return/original packaging
Make sure that the ventilation slots on the unit are not blocked or covered in any way.
otherwise the unit may overheat.
There is a risk of
fi
re!
You must not disconnect the receiver from the mains while it is in operation!
This can lead to a loss of data and corruption of the software.
Safety Instructions - Important Notes
Please keep the original packaging in case you need to return the product at any time! The receivers
are fragile due to their construction and are only adequately protected by the original packaging. If the
receiver is not shipped correctly the guarantee/warranty on it will be voided.
Before you disconnect the receiver from the mains, you must switch it to the standby mode by pressing
the standby button (on/off) on the remote control. In standby mode, any changed or new data that
are broadcast will be saved by the receiver. As soon as the receiver is in the standby mode, it can be
disconnected from the mains at any time.
Ventilation slots on the unit
Switching the receiver off
Warning!
Channel assignment
The channels available on the satellites and transponders are subject to continual change. If changes
do occur, the new channels have to be set on the receiver because the factory pre-programming
corresponds to the status on the date of manufacture. The information for these settings can be found
on the Internet or in relevant magazines.
Updating the receiver software
Your receiver was equipped in the factory with the latest software version available at that time. We
are, however, constantly working on adapting the software to the wishes of our customers and to
developments in technology. Further information on this can be found in the sections “Main Menu - Service
Menu”, “Update Firmware”.
