Kässbohrer SILO Series, Руководство пользователя

Страница: 72 / 89

71 / 88
Components on discharge cone
•
Connect the material hose to the
discharge cone by means of disc-
harge elbow (5).
When connecting the air battery and disc-
harge cone and the discharge elbow, en-
sure that right couplings are used. If not,
this can lead to malfunctions during the un-
loading process.
If required, you can mount an adapter with
a sight glass (optional) between the disc-
harge elbow and the material hose. This
adapter enables you to check that the load
is being empted continuously.
Start discharging
•
Make the hydraulic connections.
•
Using the hydraulic tip-over mec-
hanism, raise the silo tank with the
control levers.
•
Start the compressor.
•
The pressure in the silo tank incre-
ases slowly.
The compressor should only
be started when the valves are
open. Otherwise, it can be da-
maged.
•
Keep only the valve (7) of the top
air line (6) open until the inside
pressure of the silo tank is 2 bar.
Top air line
•
After the pressure reaches 2 bar,
depending on the load, fluidize
with the required pressure via the
stop valve and adjust it accordingly
during emptying.
The emptying cannot be done
unless inside pressure of the
silo tank reaches 2 bar. With
light and powdery loads, unloading can
begin as soon as the pressure is 0.7 bar.
•
Open the jet air valve on the air
battery fully in a very short time
and check the pressure on the ma-
nometer.
If no pressure is shown, the material hose
is empty. Discharge can begin.
If the pressure is constant, the material
hose is blocked. The reason for the bloc-
kage must be determined and remedied.
•
Start discharging.
•
Open the on-off valve on the ma-
terial coupling.
« Product is forced out of the silo tank with
pressure.
•
Monitor the unloading process and
the pressure. Do not go away from
the silo vehicle.
The valves for fluidiser air, jet air and top air
on the air battery are used to control the
pressure in the silo tank and thus the mate-
rial flow. Depending on the type of load, you
may have to adjust the air supply from the
air battery accordingly.