![background image](http://html1.mh-extra.com/html/jetcat/p1000-pro/p1000-pro_operating-instructions-manual_646131013.webp)
M
Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800
Wettelbrunner Straße 6
13
79282 Ballrechten-Dottingen
www.jetcat.de
GERMANY
Instruction manual JetCat-PRO engines, 1.7 - V12.01V
Data connector (A)
The data connector of the engines provides all necessary control signals for engine control as well as power on.
15pin SUB-D male connector
FCT - A MOLEX COMPANY FL, Sub-D Connector, 15-pin, straight, male
RS -No.:
812-6359
Pin-Inserts:
Sub-D-contact, Series: FK20PL, Male, Crimp, 24 → 20 AWG FK20PL-08V
RS -No.:
812-6220
Pin
Description
Info
Suggested connection
1
GND
Signal Ground
Connect to ground/negative pole of
supply battery
2
Throttle PWM input
RC-PWM Signal (THR)
Connect to servo PWM signal (0,8-
2,2ms) if throttle control should be
made via PWM signal
3
CAN-L
CAN-BUS
4
GSU-Bus-D
GSU bus (do not use!)
5
TXD 3,3V (COM1)
Serial interface transmit line
6
RXD-Cross Check, COM2
Secondary serial interface receive
signal
7
AUX PWM input
RC-PWM Signal (AUX)
8
Safety Shutdown input /
engine “kill” signal.
Safety shut down input.
This is an input for additional flight
termination systems.
This input pin should not be used to
stop the engine under normal
conditions.
Needs to be connected to GND to
allow engine to run.
This signal is only present on P1000
engines or engines with ECU
hardware setup V2.0 or higher!
Connect this pin to GND to enable
internal valves and pump!
If left open, valves and pump are
disabled by septate hardware
circuitry! (
engine cannot run).
If disconnected during engine run,
engine will be shut down
immediately with GSU error
message: “Kill Sig”
9
Power On Signal (4-14V)
See note 1 below!
Apply a positive voltage to power up
ECU/engine
Connect to positive pole of power
supply, to switch on ECU/engine
system. If disconnected ECU is
turned off. See also page 29 Engine
Power ON/OFF
10
CAN-H
CAN-BUS
11
GSU-Bus-C
GSU-bus (do not use!)
12
RXD 3,3V (COM1)
Serial interface receive line
13
+5V out, max 200mA
+5V output to GSU
14
TXD-Cross Check, COM2
Secondary serial interface transmit
signal
15
Airspeed
0-2,5V Airspeed Sensor or Analog
input