63
MAINTENANCE
- Connect the PTO shaft and install
the safety chain.
Note: Leave some slack on
the chain considering an-
gular
movements.
- Disengage the PTO when making
sharp turns.
01- SERVICING
a) DISASSEMBLING
1- Remove the lock screw.
2- Turn the guard cone until the indicated position.
3- Pull the guard cone.
4- Remove the sliding ring.
b) ASSEMBLING
5- Clean and lubricate the male
and female tubes.
6- Install the sliding ring into
the fitting with the grooves
pointing toward the tube.
7-Install the protection guards.
8- Turn the guard cone until the
indicated position.
9-Install the lock screw.
CONVENTIONAL PTO SHAFT
ATTENTION
ONLY OPERATE WITH
PTO SHAFT EQUIPPED
WITH PROTECTION
GUARDS.
A
02 - CONNECTING
Lubricate daily the male and female tubes (detail A - figure below) and further lubri
-
cation points.
ATTENTION: ALWAYS STOP THE SPRAYER AND TURN OFF THE TRACTOR ENGINE
BEFORE SERVICING THE PTO SHAFT. ALL KIND OF MAINTENANCE ON THE PTO
SHAFT MUST BE DONE WITH THE USE OF APPROPRIATE PROTECTIVE CLOTHING,
SUCH AS: GLOVES, BOOTS, GOGGLES, ETC.