34
HITCHING THE SPRAYER TO THE TRACTOR
- Mount the hydraulic control support to the tractor in a convenient position.
ATTENTION
AFTER INSTALLED, THE HYDRAULIC AND SPRAY CIRCUIT CONTROLS LEVERS
WILL BE POSITIONED CLOSE TO THE OPERATOR FOR EASY OPERATION.
AS THE OPERATOR MAY BE IN FRONT OF OR EVEN BESIDE THE CONTROL LEVERS,
THIS REQUIRES THE USE OF ORIGINAL PIN WITH COTTER PIN AND SAFETY CHAIN
PROPERLY INSTALLED TO AVOID ACCIDENTS.
ATTENTION:
OPERATE ONLY WITH PTO SHAFT PROVIDED WITH GUARD CAP.
ATTENTION
Before using the equipment for the first time, clean and lubricate every point of the PTO
shaft, as shown in the picture beside, with Lithium-based grease NGLI-2 (for further
information about the greases, refer to the lubrication table).
Lubricate daily or every 10 working hours the male and female tubes (detail B on the
figure below) and further lubrication points.