62
N
O
M
MAINTENANCE
WIDE-ANGLE C.V. PTO SHAFT
c) Assembling
- Assemble the C.V. PTO shaft as described in the figures
G
,
H
,
I
, e
J
and lubricate
it if necessary.
4 - ADJUSTING THE SHAFT LENGTH
a) Before cutting the shaft,
check for all
the possibilities of using it without reducing
its length.
Check:
- The position on the tractor drawbar.
- Whether the sprayer drawpole can be adjusted
for longer.
L
3 - REASSEMBLING
- Grease the locking collar groove (figure
G
).
- Fit the guard cap (3) and fasten it with the locking collar (4) - figure
H
.
- Hold the shaft as shown in the figure
I
and slip the guard cone (1) on. Align the
grease cup of the guard cone (1) with the bearing tab on the locking collar (4) - figure
J
.
- Push the guard (3) down so that it is engaged by the locks (2).
- Make sure that the three locks (2) are firmly engaged. If necessary, force close to
the locks as shown in the figure
J
.
- Repeat this operation on the other side of the shaft and lubricate the whole as-
sembly as indicated in figure
A
.
drawpole
drawbar
b) Cutting the shaft
- Dismantle the guard caps as shown in the figures
C
and
D
.
- Cut the two tubes (male and female) at the desired dimensions (figure
M
).
- Remove the burrs resulting from the cutting operation, as well as the filings resulting
from the burrs removal (figure
N
).
- Cut the guard caps length, using as measure the pieces of the tubes previously cut (figure
O
).
- Clean the residues of cutting.
I
J
1
4
H
3
4
G