Jacobsen Fairway 250 JGZZ250, Руководство по эксплуатации и обслуживанию

Страница: 49 / 99

en-48
7 OPERATION
G
J
H
K
M
L
9. Never start the engine when the operator is not in the seat on the tractor.
10. If components are not included on the vehicle or equipment is loose and damaged, do not operate the
tractor and attachments.
7.4 FITTING THE CUTTING UNIT TO THE MACHINE_____________________________
Cutting Unit Mounting
1. Start the engine and lower the lift arms, stop engine
and remove ignition key.
2 Position cutting unit under lift arm and slide yoke onto
shaft in direction A.
3 Fit retainer (B) to shaft and insert bolt (C) through
retainer and shaft, fit nut (D).
4. fit retainer plate (E) and secure with screws and nuts
(F).
5. Fit chain (G) to clevis on rear of cutting unit using pin
(H) and ‘R’ clip (J).
Hydraulic Motor Mounting
1. Lubricate the motor and reel splines with Shell
Malleus JB1 Grease Part number MBE3927.
2. Assemble hydraulic motor (K) to bearing housing,
secure with nuts (L) and washers (M) to studs.
WARNING
DO NOT USE ON THE SLOPES GREATER THAN
20°
B
C
D
E
F
A