9
item Controller BL 1-04 /C
― Product manual
2.3 Target group
Over its entire service life, work on the servo drive, with the exception of its operation, may only be performed by specialist per
-
sonnel and/or instructed persons who have been trained for the required tasks. The servo drive is to be operated by the user.
Trained and qualified personnel
Qualified personnel in the sense of this product manual are persons who are sufficiently familiar with the project, set-up,
installation, commissioning and operation of the servo drive as well as with all of the warnings and precautions and who are
sufficiently qualified in their field of expertise:
▪ They have been trained, instructed and authorised to perform the switching and earthing (grounding) of the devices/sys
-
tems in line with the applicable safety standards and to label them accordingly as per the job requirements.
▪ The service and maintenance personnel have undergone special training in the context of ESD protection measures.
▪ They have been trained and instructed in line with the applicable safety standards in terms of the maintenance and use of
adequate safety equipment.
▪ They have completed first aid training.
2.4 General safety instructions
DANGER
Danger to life due to electric shock!
Non-compliance with the safety instructions will lead to a potentially fatal electric shock.
The general set-up and safety rules and regulations concerning the work on power installations (e.g. DIN, VDE, EN, IEC or any
other national or international rules and regulations) must be complied with.
▪ Safety-critical applications of the servo drive are not allowed unless specifically approved by the manufacturer.
▪ For information about the EMC-compliant installation, see section 9.1 Notes concerning the safe and EMC-compliant instal
-
lation on page 52. The manufacturer of the machine or system is responsible for ensuring compliance with the limits that
are specified by the applicable national rules and regulations.
▪ The ambient conditions that are specified in the product manual must be strictly observed.
▪ The technical data as well as the connection and installation conditions of the servo drive are stated in this document and
must be complied with at all times.
▪ The servo drive has an IP20 protection rating and a pollution degree rating of 2. Ensure that the environment corresponds
to this protection rating and pollution degree rating.
▪ Use only original accessories and original spare parts that have been approved by the manufacturer.
▪ The servo drives must be connected to the mains power supply in accordance with the country-specific regulations (EN
standards, VDE rules) so that they can be disconnected from the mains power supply by way of suitable disconnectors (e.g.
main switches, contactors, circuit breakers).
▪ Use gold contacts or contacts with a high contact pressure for switching the control contacts.
▪ You can protect the servo drive with an AC/DC-sensitive residual-current device (RCD) with 300 mA minimum.
▪ Preventive interference suppression measures should be taken for the switchgear. This can be done, for example, by
connecting RC circuits or diodes to the contactors and relays.
DANGER
