Illustra Flex Series Installation and Configuration Guide
8200-1456-01 D0
59
Mirror and Flip settings are not selected by default. The video pane updates to display the
new settings.
Note:
When wall mounting the camera you should select Flip to correct the lens
orientation.
- End -
Focus/Zoom
The Focus is manually configured on initial setup. The
One Touch
button can be used to
automatically focus the area of view. The plus and minus arrows are used to manually fine tune the
image. The Zoom slider bar is used to manually zoom in and out to manually configure to picture. The
table below describes the features supported by each camera.
Table 54 Lens features supported for the Indoor and Outdoor Dome, Bullet, and Box cameras
Indoor Dome
Outdoor Dome
Bullet
Box
Mechanical Focus
X
Motorized Focus
X
X
X
Mechanical Zoom
X
Motorized Zoom
X
X
X
Lens Calibration
X
X
X
Lens Selection
X
Auto One Touch
X
X
X
X
NOTE
: Auto back focus
Procedure 56 Adjust Camera Focus / Zoom
Step Action
1
Select
Setup
on the Web User Interface banner to display the setup menus.
2
Select the
Picture Basic
tab from the
Basic Configuration
menu.
3
Select
to start the video stream if it is not already active.
4
Use the plus and minus arrows to manually configure the focus and the slider bar to adjust
zoom settings until the image in clear. The video pane updates to display the new settings.
- End -
Procedure 57 Adjust Camera Focus using OneTouch Autofocus
1
Select
Setup
on the Web User Interface banner to display the setup menus.
2
Select the
Picture Basic
tab from the
Basic Configuration
menu.
3
Select
to start the video stream if it is not already active.
