IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 41 / 167

39
4
HANDLING AND INSTALLATION
302.034
4.5.5 Levelling and alignment
❑ ❑ ❑ ❑
Foreword
Alignment between the feeder and lathe is the most critical installation phase; therefore,
this operation should be carried out by experienced personnel with the greatest accuracy.
CAUTION: bad alignment can be the main cause of feeder malfunction and resulting
damage.
❑ ❑ ❑ ❑
Preliminary procedure
See paragraph 4.4.5
❑ ❑ ❑ ❑
Levelling
See paragraph 4.4.5
❑ ❑ ❑ ❑
Alignment
See paragraph 4.4.5
❑ ❑ ❑ ❑
Positioning adjustment
After checking alignment of the feeder with either the
thread or the bar, any required corrections should be
carried out.
Adjust height by turning the screws in the support feet;
carry out lateral adjustment with calibrated mallet
blows on the sides of frame
A .
During this phase, any adjustment carried out during
levelling should be preserved; therefore, in most cas-
es, feeder positioning will be the result of a good ad-
justment compromise
•
Position the remaining eight plates under the axial
sliding frame in the positions indicated in the figure,
then tighten the cone end grub screws
B .
34.048 Ec. 0
A A
34.049 Ec. 0
B
B