IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 163 / 167

58
3
OPERATION INFORMATION
302.035
ERROR CAUSE CURE
The feed motor has stopped or can-
not be restarted.
Motor brushes are worn out. Replace brushes.
Short circuit in the motor
Check the motor.
Failure of the speedometer dynamo
Temperature of the drive dissipator
has reached the max. value.
ERROR CAUSE CURE
During the facing stroke, the bar
met with an obstacle, before reach-
ing the section defined in
parame-
ter 10 .
There is an obstacle inside the
spindle.
Remove the obstacle.
Difetto di funzionamento dell’innesto
elettromagnetico (
Y10
) d’innesto
frizione.
Verificare e/o sostituire l’elettromag-
nete.
L’innesto elettromagnetico della
frizione é mal regolato.
Regolare l’innesto elettromagnetico.
Difetto di funzionamento della
frizione. Verificare il livello dell’olio della
frizione e lo stato di usura dei dischi.
Encoder failure.
Check the electric connection.
Check the encoder splining into the
pinion shaft.
Replace the encoder.
Faulty board. Check and/or replace the board.
227
E r r o r : p r o t e c t e d m o t o r
d r i v e ( 2 2 7 )
230
( 2 3 0 )
E r r o r : s t a t i o n a r y p o s i t i o n
b e f o r e i m p u l s e s
section with error 230
facing flag
C
parameter 10
35.012 Ec.0