IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию, Страница: 150 / 167

45
3
OPERATION INFORMATION
302.035
Allows the exit from parameters and from functions protected by the access code
press:
Resets the piece counter
press:
It is the function to display the total amount of the driving motor operation hours.
press:
Such amount has to be reset if the motor replacement takes place.
INFORMATION: if the card has to be replaced, check and note down the
hour amount, as it is to be reset and cannot be set again.
It is the function to display the partial amount of the driving motor operation hours.
press:
to reset
press:
When power supply is connected from the lathe
it appears:
it means that 1250 partial operation hours are over, and that the motor brush
inspection is needed (see “Use and maintenance manual”).
After servicing, the hour counter has to be reset following the above-mentio-
ned instructions.
Such hour amount has to be reset also if the motor replacement takes place.
INFORMATION: if the card has to be replaced, check and note down the
hour amount, as it is to be reset and cannot be set again.
F
1
U s e r m o d e F
2
0 p i e c e s
F
3
M o t. T h o u r F
4
M o t. P h o u r
Function F1
Function F2
+
Function F3
Function F4
+
A T T E N T I O N : e x e c u t e m o t o r
m a i n t e n .