IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 157 / 167

52
3
OPERATION INFORMATION
302.035
ERROR CAUSE CURE
The bar failed to reach the value
entered into
parameter 4 , following
the “COLLET CLOSING” phase.
Parameter 4
value exceeds the bar
feed.
Check the bar feed and enter into
parameter 4
a value at least 2 mm
less.
The lathe collet fails to open prop-
erly.
Check the lathe collet.
The thrust received by the bar is not
sufficient.
Check and increase thrust value
(see paragraph “NC functions -
Description and operation”)
Electromagnetic clutch operation
fault (
Y10 )
Check and/or replace the electro-
magnet.
Electromagnetic clutch bad adjust-
ment.
Adjust the electromagnetic clutch.
Clutch operation fault.
Check the clutch oil level and disk
wear.
Encoder failure.
Check the electric connection.
Check the encoder splining into the
pinion shaft.
Replace the encoder.
Faulty board. Check and/or replace the board.
ERROR CAUSE CURE
The bar exceeds value entered into
parameter 5 during feeding.
Parameter value 5 is too low, less
than the bar feed.
Check the bar feed and enter a
value at least 2 mm higher into
parameter 5 .
The lathe bar catch is not correctly
positioned.
Check the bar catch.
Electromagnetic clutch operation
fault (
Y10 )
Check and/or replace the electro-
magnet.
Electromagnetic clutch bad adjust-
ment.
Adjust the electromagnetic clutch.
Clutch operation fault.
Check the clutch oil level and disk
wear.
Encoder failure
Check the electric connection.
Check the encoder splining into the
pinion shaft.
Replace the encoder.
Faulty board. Check and/or replace the board.
211
E r r o r : s h o r t f e e d ( 2 1 1 )
212
E r r o r : l o n g f e e d ( 2 1 2 )