IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 36 / 167

34
4
HANDLING AND INSTALLATION
302.034
•
Carry out the required connections by turning the
feet screws.
❑
❑ ❑
❑
Alignment
To obtain alignment lead a (ø 1 mm) nylon thread be-
tween the lathe collet and the feeder rear plate, then
proceed as follows:
•
place a drilled bush A in the lathe collet;
•
stretch the thread to reach the (red) drilled screw B
located in the rear plate;
•
use a sliding calliper to check alignment near the
sleeve
C and the spindle D ; adopt a tolerance of
0.15 mm in all four directions.
It is also possible to carry out alignment by placing a
bar in the guides. Proceed as follows:
•
prepare a perfectly straight ground bar, having an
outside diameter equal to the max. spindle bar pas-
sage and a length equal to twice the coupling dis-
tance (see item
B paragraph 4.4.3);
•
place the bar in the guide and cause it to slide for-
wards and backwards in the spindle, until almost
reaching the lathe collet area.
+
-
34.030 Ec. 0
34.039 Ec. 0
B
A
34.040 Ec. 0
C
D
34.041 Ec. 0