IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 132 / 167

27
3
OPERATION INFORMATION
302.035
Controls the reduced speed value in the slowing down section
(parameter 10)
.
Accepts values from 0 to 750 mm/sec.
Controls the thrust value of the bar-pusher introducing the bar into lathe collet.
Enabled in the slowing down section
(parameter 10)
.
Accepts values from 0 to 125.
It acts on the clutch electromagnet and is independent from the value assigned
to the function F1 (see paragraph “CN functions - Description and use”).
Controls the bar impulse number to make introduction into lathe collet easier.
Controls any slowing down point (parameter 10) .
Description of phases:
– the bar is fed along the slowing down section;
– the bar meets with the obstacle (collet), thus activating impulses,
– the bar enters into collet.
INFORMATION: should the bar find another obstacle before getting out
of the slowing down section, the bar feeder stops in an “EMERGENCY”.
Controls the impulse forward-backward stroke (parameter 13) .
11
Phase Default
bar
change
over
100 mm/
sec
: > ( mm / s e c )
n o . 1 1 c o l l e t e n t r y s p e e d
12
Phase Default
bar
change
over
80
: >
n o . 1 2 c o l l e t e n t r y c l u t c h
13
Phase Default
bar
change
over
8
: >
n o . 1 3 i m p u l s e n u m b e r
14
Phase Default
bar
change
over
10 mm
: > ( mm )
n o . 1 4 i m p u l s e s t r o k e