IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 53 / 167

51
5
ADJUSTMENTS AND SETTING-UP
302.034
❑
Example 1
The previous machining cycle had been carried out under these conditions:
The new machining cycle requires feeding of 10 mm bars.
In this case, the half bushes and bar-pusher collet must be replaced and
the magazine and clamps must be adjusted.
❑
Example 2
The previous machining cycle had been carried out under these condi-
tions:
The new machining cycle requires feeding of 14 mm bars.
In this case, the half bushes, bar-pusher and bar-pusher collet must be
replaced and the magazine and clamps must be adjusted.
❑
Example 3
The previous machining cycle had been carried out under these condi-
tions:
The new machining cycle requires feeding of 25 mm bars.
In this case, the guides, half bushes, bar-pusher and bar-pusher collet
must be replaced and the magazine and clamps must be adjusted.
The information contained in this paragraph refers to Example 3, i.e. to
the cases where it is necessary to carry out all adjustment operations
and feeder set-up.
These operations are listed and then described below.
5.3.1 Guides, half bushes, bar-pusher and collet - Replacement
5.3.2 Clamps - Replacement
5.3.3 Bar guide plates and bar selectors - Adjustment
5.3.4 Clamps - Adjustment
Guide
diameter (mm)
Bar-pusher
diameter (mm)
Bar diameter
(mm)
17 15 8
Guide
diameter (mm)
Bar-pusher
diameter (mm)
Bar diameter
(mm)
17 15 8
Guide
diameter (mm)
Bar-pusher
diameter (mm)
Bar diameter
(mm)
17 15 8