IEMCA BOSS 542 CNC, Руководство по эксплуатации и техническому обслуживанию

Страница: 80 / 167

78
6
USE AND OPERATION
302.034
6.6. FEEDER STOP
❑
Feeder emergency stop
CAUTION: if the emergency stop is used during
lathe machining, before resuming work make
sure that the sudden stop has not created any haz-
ardous condition (e.g., if the tool was cutting
chips, move the tool away from the workpiece be-
fore restarting the lathe).
•
To stop the feeder in an emergency, press an emer-
gency push-button, either that of the lathe or that of
the feeder.
❑
Feeder stop at work end
CAUTION: do not use emergency buttons for
normal machine stop.
•
Complete the operations in your work schedule.
•
Stop the feeder by pressing the button .
•
Stop the lathe.
6.7. AUTOMATIC CYCLE START AFTER MANUAL CYCLE OPERA-
TIONS
•
If the bar-pusher has been moved while electric pow-
er was disconnected, a “BAR FEEDER ZERO SET-
TING” should be performed in the following way:
press
if the upper guides are not closed, the feeder will not
perform “BAR FEEDER ZERO SETTING”; messages
are displayed concerning the operations to carry out in
order to bring the guides to the required position.
After carrying out the required operations;
press
•
Check that the bar is in the required position in the
lathe collet and that the collet is closed.
•
Move the feeder to the “WORKING” phase as
follows:
press
if the feeder is not in the right status, it will not move to
the “MACHINING” phase; messages are displayed
concerning the operations to carry out in order to ob-
tain to the appropriate feeder status.
After carrying out the required operations:
press
•
Press
to select the automatic mode; the feeder will wait for an
“OPEN COLLET” signal from the lathe.
+
+
+
+