IBM Storwize V7000, Руководство по обслуживанию

Страница: 97 / 172

7. Pull out the handle to its full extension.
8. Grasp canister and pull it out.
9.
Insert the new canister into the slot with the handle pointing towards the
center of the slot. Insert the unit in the same orientation as the one that you
removed.
10. Push the canister back into the slot until the handle starts to move.
11. Finish inserting the canister by closing the handle until the locking catch clicks
into place.
If the enclosure is powered on, the canister starts automatically.
12. Reattach the data cables.
Replacing an expansion canister
This topic describes how to replace an expansion canister.
Attention: If your system is powered on and performing I/O operations, go to
the management GUI and follow the fix procedures. Performing the replacement
actions without the assistance of the fix procedures can result in loss of data or
access to data.
Even though many of these procedures are hot-swappable, these procedures are
intended to be used only when your system is not up and running and performing
I/O operations. Unless your system is offline, go to the management GUI and
follow the fix procedures.
Be careful when you are replacing the hardware components that are located in the
back of the system that you do not inadvertently disturb or remove any cables that
you are not instructed to remove.
Be aware of the following canister LED states:
svc00631
Figure 25. Removing the canister from the enclosure
Chapter 8. Removing and replacing parts
81